Loading ...
Loading ...
Loading ...
Aluminum hub cap
#
To remove: position socket 2 on hub cap
1.
%
The socket can be found in the tire-change
tool kit.
#
Position wheel wrench 3 on socket 2.
#
Using wheel wrench 3, turn hub cap 1
counter-clockwise and remove it.
#
To install: position hub cap 1 and turn until
it is completely flush with the wheel.
#
Position socket 2 on hub cap 1.
#
Attach wheel wrench 3 to socket 2 and
tighten the hub cap clockwise.
Specified tightening torque: 18 lb-ft
(25 Nm).
Raising the vehicle when changing a wheel
Requirements:
R
There are no per sons in the vehicle.
R
The vehicle has been prepared for a wheel
change (→ page 400).
R
The hub caps have been removed
(→ page 400).
Important notes on using the jack:
R
Use only the vehicle-specific jack that has
been tested and approved by Mercedes-Benz
to raise the vehicle.
R
The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
R
The jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large,
flat, load-bearing, non-slip underlay.
R
The foot of the jack must be positioned ver ti‐
cally under the jack support point.
Rules of conduct when the vehicle is raised:
R
Never place your hands or feet under the
vehicle.
R
Never lie under the vehicle.
R
Do not start the engine and do not release
the electric parking bra ke.
R
Do not open or close any doors or the trunk
lid.
Wheels and tires
401
Loading ...
Loading ...
Loading ...