Loading ...
Loading ...
Loading ...
(158,1)
北米Model "A3230BE-A" EDITED: 2021/ 5/ 19
Registration of the rear gate height:
Memory switch status
1) ON status
2) OFF status
To register the rear gate height, perform
the following procedures.
1. Open the rear gate using the power
rear gate function.
2. With the rear gate at the desired
height, stop it using the power rear gate
function.
3. Press the memory switch to select the
“ON” status.
Power rear gate button on the inside edge
of the rear gate
1) Power rear gate button
4. With the rear gate at the desired
height, press and hold the power rear gate
button on the inside edge of the rear gate
until an electronic chirp is heard and the
hazard warning flashers flash three times.
The electronic chirp and the flashing
hazard warning flashers confirm the se-
lected rear gate height has been regis-
tered.
NOTE
. To change the registered height,
press the memory switch to select the
“OFF” status and perform the register-
ing procedure again.
. It is possible to register the height
from a completely closed position to
approximately 2 in (5 cm) open.
Retrieval of the rear gate height:
To open the rear gate and stop it at the
registered height, perform the following
procedure.
1. Press the memory switch to select the
ON status.
2. Press and hold any of the power rear
gate switches.
Even if any of the power rear gate switches
are pressed and held while the memory
switch is in the OFF status, you can stop it
at the registered height by pressing the
memory switch to select the ON status
before the rear gate reaches the registered
height.
NOTE
The rear gate will open to the position
that is stored in the memory function
even if the rear gate is opened by the
reverse function.
Rear gate
156
Loading ...
Loading ...
Loading ...