Loading ...
Loading ...
Loading ...
Link speed and duplex settings
NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most situations,
leave the printer in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the
printer from communicating with other network devices. To make changes, use the printer control panel.
NOTE: The printer setting must match the setting for the network device (a network hub, switch, gateway,
router, or computer).
NOTE: Making changes to these settings causes the printer to turn o and then on. Make changes only when
the printer is idle.
1. Open the HP Embedded Web Server (EWS):
a. Print a conguration page to determine the IP address or host name.
i. Press and hold the Resume button until the Ready light begins blinking.
ii. Release the Resume button.
b. Open a web browser, and in the address line, type the IP address or host name exactly as it displays
on the printer conguration page. Press the Enter key on the computer keyboard. The EWS opens.
NOTE: If the web browser displays a message indicating that accessing the website might not be
safe, select the option to continue to the website. Accessing this website will not harm the computer.
2. On the Networking tab, click the Advanced link in the left navigation pane.
3. In the Other Settings area, select one of the following options:
Automatic: The print server automatically congures itself for the highest link speed and
communication mode allowed on the network.
10T Full: 10 megabytes per second (Mbps), full-duplex operation
10T Half: 10 Mbps, half-duplex operation
100TX Full: 100 Mbps, full-duplex operation
100TX Half: 100 Mbps, half-duplex operation
4. Click the Apply button. The printer turns o and then on.
60 Chapter 5 Manage the printer ENWW
Loading ...
Loading ...
Loading ...