Loading ...
Loading ...
Loading ...
196 IN CASE OF EMERGENCY
Replacing Exterior Bulbs
Headlamps
1. Raise the hood to access the rear of the
headlamp housing.
2. Slide the red lock tab rearward on the
connector, then depress the tab and
remove the connector from the bulb.
3. Twist the headlamp bulb and pull the bulb
from the headlamp housing.
4. Install the new headlamp bulb and twist
until locked into the headlamp housing.
5. Connect the wiring connector to bulb and
slide red lock tab forward.
Front Park/Turn Signal Lamps
1. Raise the hood to access the rear of the
headlamp housing.
2. Twist the turn signal socket and remove
from the headlamp housing, then pull the
bulb out.
3. Push the new bulb into the socket and
reinstall the socket by twisting until locked
into the headlamp housing.
Fog Lamps
NOTE:
Access to the fog lamp bulb is from the rear of
the fascia. On the left rear side of the fascia,
remove the push pin and lower the hinged
access door on the air dam.
1. From behind the bumper fascia, or the
access panel on the air dam, squeeze the
two tabs on the side of the bulb socket and
pull straight out from the fog lamp.
2. Disconnect the wire harness from the bulb.
3. Reconnect the wiring harness to the new
bulb and reinstall by inserting the new bulb
straight into the fog lamp until it locks into
place.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with an oily
surface, clean the bulb with rubbing alcohol.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with an oily
surface, clean the bulb with rubbing alcohol.
20_RT_OM_EN_USC_t.book Page 196
Loading ...
Loading ...
Loading ...