Loading ...
Loading ...
Loading ...
10 GETTING TO KNOW YOUR VEHICLE
Replacing The Battery In The Key Fob With
Remote Control
The replacement battery is one CR2032
battery.
NOTE:
Perchlorate Material — special handling may
apply. See www.dtsc.ca.gov/hazard-
ouswaste/perchlorate for further informa-
tion.
Do not replace coin battery unless the instru-
ment cluster display shows the message
“Key Fob Low Battery”.
Do not touch the battery terminals that are
on the back housing or the printed circuit
board.
1. Remove the emergency key by sliding the
mechanical latch on the back of the key
fob sideways with your thumb and then pull
the key out with your other hand.
Emergency WIN Key Removal
2. Gently pry the two halves of the key fob
apart. Make sure not to damage the seal
during removal.
Separating WIN Key Fob Case
3. Remove the battery by turning the back
cover over (battery facing downward) and
tapping it lightly on a solid surface such as
a table or similar, then replace the battery.
When replacing the battery, match the (+)
sign on the battery to the (+) sign on the
inside of the battery clip, located on the
back cover. Avoid touching the new battery
with your fingers. Skin oils may cause
battery deterioration. If you touch a battery,
clean it with rubbing alcohol.
4. To assemble the key fob case, line up the
two case halves, and snap them together.
Programming Additional Key Fobs
Programming the key fob may be performed by
an authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it
cannot be repurposed and reprogrammed to
another vehicle.
20_RT_OM_EN_USC_t.book Page 10
Loading ...
Loading ...
Loading ...