Loading ...
Loading ...
Loading ...
Installation instructions
7
Before connection
Important!
■
Ensure that your appliance has not suffered any damage during transport (bent door or seal,
etc.). If you notice any kind of damage, contact your retailer before using the appliance.
■
In order to easily locate the make, model number, etc. of your appliance, we recommend that you
note this information on the ‘Warranty and service’ page.
■
If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service
department or by a similarly qualified person on order to avoid danger.
■
Installation should only be performed by installers and qualified technicians.
Electrical specifications
■
Electrical connection rating: 3.4 kW
■
Voltage/frequency: 220-240 V / 50 Hz
■
Current: 16 A
Please verify electrical specifications by checking the appliance rating label.
Electrical connection
Ensure that:
■
The electrical installation has sufficient voltage.
■
The electrical wires are in good condition.
■
The diameter of the wires complies with the installation requirements.
■
Your electrical installation is equipped with 16-ampere thermal-sensitive protection.
■
The oven is connected to a single phase 220-240 V 50 Hz supply using a 1.5 mm
2
cable and
connected to earth. The supply must be protected by a suitably rated circuit breaker in
accordance with the installation regulations.
■
A suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations. The isolating switch must be of an approved type and provide a 3 mm air
gap contact separation in all poles (or in all active [phase] conductors if the local wiring rules
allow for this variation of the requirements)
■
The isolating switch will be easily accessible to the customer with the oven installed.
■
If in doubt, consult your electrician.
Electrical connections should be completed before the appliance is placed in the wall unit.
The appliance must be recess-fitted correctly to ensure electrical safety. During recess fitting and
maintenance operations, the appliance must be disconnected from the power supply; fuses must
be cut off or removed.
If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service
or a similarly qualified person so as to prevent a hazard.
Important:
We cannot accept liability for any accident or incident resulting from non-existant, defective or
incorrect grounding.
If the oven malfunctions in any way, disconnect it from the power supply or remove the fuse for
the oven’s connection line.
Loading ...
Loading ...
Loading ...