Loading ...
Loading ...
Loading ...
15
10. Adjusting the appliance in the niche
Adjust the appliance to the existing furniture.
Keep the straight edge on the door, above the
positioning supports.
The positioning supports are set out for the following
overall strengths of the furniture doors to be mounted.
–19 mm
–38 mm
Re-examine the actual thickness of the doors to be
mounted in order where necessary, to be able to
compensate possible digressions.
The height-adjustable feet on the front and rear can
all be adjusted from the front.
Front: with a fixed spanner SW 13 mm
Rear: with a socket spanner with flexible shaft
m Caution!
Never use a rechargeable screwdriver for setting
the height of the appliance.
A mark is made on the base of the appliance which serves
as a standard measurement for setting the height.
When setting the height, raise the mark to 32 mm above
the ground.
Screw the height-adjustable screws as far down-
wards as possible until the marking on the base has
reached the given height (32 mm).
Note:
This dimension is very important for the subsequent
adjustment of the cabinet frontage.
Adjust the front of the appliance with the spirit level.
Note:
– Do not tip the appliance in the niche! When screwing
down the height adjustable feet, proceed step by step.
Lower by alternating left to right.
– The rear feet can be set easier when the appliance
is not loaded on the rear.
– When using a wooden plank as an alternative anti-tilt
mechanism as in point 7 of these mounting instruc-
tions, turn the appliance as far as it will go against the
wooden plank. Do not bend against the wooden
plank.
Loading ...
Loading ...
Loading ...