Loading ...
Loading ...
Loading ...
12
Subsurface wooden floors
The wood screws (5 x 60 mm and 4 x 15 mm) which are
supplied should be used for wooden floors.
Drilling guide holes:
3 mm for woodscrews (5 x 60 mm)
2 mm for woodscrews (4 x 15 mm)
Make sure that the screws 5 x 60 grip at least 19 mm
into the solid subsurface.
Tightly screw the anti-tilt ribs. Re-examine to make
sure that the screws are firmly tightened.
Subsurface concrete
m
Warning!
When installing or working with floor anchors always
use protective glasses and other protective equipment
or protective clothing – risk of injury!
Floor anchors are not suitable for use in connection
with lightweight construction masonry, breeze blocks
or tiles.
Never use floor anchors in fresh concrete which has
not hardened.
In drilling holes for these floor anchors, do not use core
drills.
Use a floor anchor M8 and a screw M8. Additionally use
the (5 x 60 mm und 4 x 15 mm) woodscrews supplied.
Drill a hole with a 10 mm diameter having a depth
a little more than the raising depth. Use the drill
supplied.
Clean the hole or drill a little deeper.
By hand, screw into the dowel until you can feel
resistance.
Strike the dowel and screw into the hole until the head
of the screw has a 13 mm distance to the anti-tilt
securing device.
Screw tightly.
Additionally use the supplied wood screws
(if the subsurface allows).
6. Attaching an additional anti-tilt
mechanism
Important note:
As far as possible, always screw the wooden plank to the
rear wall of the niche.
If the anti-tilt ribs cannot be fastened securely, a wooden
beam can be used above the appliance as an alternative
anti-tilt mechanism. Care should be taken that there is not
a gap between the appliance and the wooden beam.
Cut the wooden plank to the required length
(cross section min. 8 x 10 cm).
The length should correspond to the width of the
installation niche!
Note:
– If the installation niche is deeper than the appliance,
select a stronger beam or use two, one behind the
other.
– The plank must overlap the appliance by at least
50 mm.
Loading ...
Loading ...
Loading ...