Loading ...
Loading ...
Loading ...
2271A
Operators Manual
18
The Setup menu leads to these submenus:
Measure Setup – This menu has options and parameters for pressure
measurement. See the Measurement Setup section for detailed information on
each menu item.
Tasks – This menu contains selections to configure and run pre-programmed
functions (tasks). See the General Tasks section for detailed information on each
menu item.
HART Tasks – This menu is only active when the Product is in HART mode.
Push on the front panel to access this menu. The menu contains these
selections:
• Trim PV Zero
• Trim Current Output
• Trim by Re-Range
• Write LRV and URV
• HART Diagnostics
• Write PV Unit
• Write Tag
• Write Message
• Write Description
Module Information - This shows the PMM configuration and can be used to
make selections regarding which PMMs and mode to use. See Module Selection
for detailed information on each menu item.
Control Setup - This menu contains options and parameters for pressure
control. See the Pressure Control Settings section for detailed information on
each menu item.
Instrument Setup - This menu contains general instrument options and
parameters. See the Instrument Setup Menu section for detailed information on
each menu item.
Diagnostic - This menu contains system self-tests, that include:
• System – Shows information about the Test Port Vent Value, Ref Port Vent
Value, and Pressure Switch Input.
• Measure – Shows PMM information in real time including PMM,
Temperature, Pressure, whether the Test Valve and Ref Valve is open or
closed. A Pneumatic Self Test can also be run from this location.
• Control – Shows Port Pressure, Control Module, and Control Coefficient
information. An Autotune feature is available from this location to tune the
PCM.
• Remote Interface – Use this menu to access RS-232, USB, or Ethernet
information.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...