Loading ...
Loading ...
Loading ...
1. In the Site Navigation pane, select Devices and then select Cameras.
2. Select the relevant PTZ camera in the Overview pane.
3. On the Patrolling tab, select the patrolling profile in the Profile list.
4. Select the preset position for which you want to change the time:
5. Specify the time in the Time on position (sec) field.
6. If required, repeat for other preset positions.
Customize transitions (PTZ)
By default, the time required for moving the camera from one preset position to another, known as transition,
is estimated to be three seconds. During this time, motion detection is by default disabled on the camera,
because irrelevant motion is otherwise likely to be detected while the camera moves between the preset
positions.
You can only customize speed for transitions if your camera supports PTZ scanning and is of the type where
preset positions are configured and stored on your system's server (type 1 PTZ camera). Otherwise the Speed
slider is grayed out.
You can customize the following:
l
The estimated transition time
l
The speed with which the camera moves during a transition
To customize transitions between the different preset positions:
1. In the Site Navigation pane, select Devices and then select Cameras.
2. Select the relevant PTZ camera in the Overview pane.
3. On the Patrolling tab, in the Profile list, select the patrolling profile .
4. Select the Customize transitions check box.
Transition indications are added to the list of preset positions.
Administrator manual | XProtect® VMS 2023 R1
239 | Configuration
Loading ...
Loading ...
Loading ...