Loading ...
Loading ...
Loading ...
2N TELEKOMUNIKACE a.s., www.2n.cz 22/134
Remove the cover from the walled-in flush mounting box. 2N Indoor Compact
®
Remove the pre-prepared cabling, UTP cable, doorbell twin cable and power supply
cable. Shorten the cables to 150 mm or less as required. Connect the doorbell twin
cable or power supply cable to the connector provided. Crimp the RJ-45 connector
onto the UTP cable. Take and lean its bottom edge against the 2N Indoor Compact
®
wall below the flush mounting box. First plug the green power/doorbell connector.
Connect the LAN connector. Put the cables carefully in the pre-drilled 2N Indoor
®
back slot to prevent them from blocking any horizontal levelling movement Compact
during the final installation stage. Insert in the flush mounting 2N Indoor Compact
®
box making sure that it clicks onto the levelling pins, which allow for a 5–6 ° inclination
. Apply the box screw nuts with the on either side for accurate horizontal levelling
hexagon key wrench provided. Level with a water level and 2N Indoor Compact
®
tighten the screws gently. Now is ready for basic operation.2N Indoor Compact
®
2N Indoor Compact
®
consumption with variable power supplies:
Supply type Consumption
PoE, IEEE 802.3af 12 W
12 V / 1 A 12 W
Warning
Do not connect any external power supply if PoE is used and vice versa.
If you use a power adapter other than the recommended one, do not
exceed the 12 V rated supply voltage. Also check the supply voltage
polarity. Higher voltage values or misconnections may result in an
irreplaceable device damage.
Loading ...
Loading ...
Loading ...