Loading ...
Loading ...
Loading ...
ScopeMeter
®
Test Tool
Recorder Functions
33
Turn Off the TrendPlot Display
Push 4 to exit the recorder function.
Recording Scope Waveforms In Deep Memory (Scope Record)
The SCOPE RECORD function is a roll mode that logs a long waveform of each active input. This
function can be used to monitor waveforms like motion control signals or the power-on event of
an Uninterruptable Power Supply (UPS). During recording, fast transients are captured. Because
of the deep memory, recording can be done for more than one day. This function is similar to the
roll mode in many DSOs but has deeper memory and better functionality.
Starting a Scope Record Function
To record, for example, the input A and input B waveform:
1. Apply a signal to input A and input B.
2. Press
Q to open the RECORDER main menu.
3. Use the cursor and E to highlight Scope Record and start the recording.
The waveform moves across the screen from right to left like on a normal chart recorder. See
Figure 18.
Figure 18. Recording Waveforms
Observe that the screen shows:
• Time from start at the top of the screen.
• The status at the bottom of the screen that includes the time/div setting as well as the total
timespan that fits the memory.
Note
For accurate recordings allow the test tool to warm up for a minimum of five minutes. For
long recordings, make sure the power supply is connected.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...