Loading ...
Loading ...
Loading ...
User’s Manual
22
You can use H-34, configure F-08 and F-09 to adjust the vertical and horizontal positions,
but using H-34 is more intuitive.
H-35 adjust the up limit manually (recommended for straight boom gate or fence boom gate,
with boom length of 5 meters or more)
After entering the H-35 command, the LED shows L-00, and then the boom rises. After the
boom finds the up limit, the buzzer beeps, and the LED changes to L-01, meaning that the
up limit has been found. At this moment, the gate stops, and you need to manually find the
vertical and horizontal positions of the boom:
1) Press and hold Close, the boom works in the closing direction, until it is in the required
vertical position.
2) Press Settings to confirm the vertical position, then the LED shows L-02, meaning that
the boom gate finishes finding the vertical position.
3) Continue to press and hold Close until the boom is in the desired horizontal position.
4) Press Settings to confirm the horizontal position. After you hear the sound from the
buzzer, the boom gate goes back to the normal working status.
If the boom does not reach the desired position after adjustment, you can press Open or
Close to adjust the position. During the adjustment process, if you do not release the Open
or Close button when the boom reaches the up or down limit, the controller will stop the
motor, and the buzzer makes continuous buzzes for alarm.
If H-33 is set to 1, the boom gate can work normally after manual adjustment. If H-33 is set
to 0, the parameters manually adjusted are saved, and they will take effect only when H-33
is set to 1.
Adjust the up limit manually Figure 3-9
H-35 adjust the up limit manually (recommended for
straight boom gate or fence boom gate, with boom
length of 5 meters or more)
The boom gate works at the speed of F-13 value
H-36 adjust the down limit manually
(recommended when there is an eave)
The boom gate works at the speed of F-13
value
H-36 adjust the down limit manually (recommended when there is an eave)
After entering the H-36 command, the LED shows L-00, and then the boom rises. After the
boom finds the down limit, the buzzer beeps, and the LED changes to L-01, meaning that
Loading ...
Loading ...
Loading ...