Siglent REFL-SSA3000X Manual

Loading ...

SIGLENT

SSA3000X User Manual 35

Add point

Add a new point for editing.

X-axis

Edit the X-axis value (frequency or time) of the current point. If the X-axis unit is

frequency and the Ref Freq is enabled, edit the frequency difference between the

frequency of the current point and the center frequency.

Amplitude

Edit the amplitude of the current point or line. If the Ref AMPT is enabled, edit the

amplitude difference between the amplitude of the current point and the reference level.

Del Point

Delete the point you are editing.

Del All

Delete all point.

Save/Recall

Save or load the limit file.

2.2.6.5 Test

Enable or disable the limit test function.

2.2.6.6 Setup

1. Fail to stop

Select whether the instrument will continue or stop operation when a failure occurs.

2. Buzzer

Turn on or off the buzzer. When the buzzer is on, it beeps when a failure occurs.

3. X Axis

Set the X-axis unit to frequency or time unit.

Note that all the points of the current limit line will be deleted when the X-axis unit changes.

2.2.7 TG（Tracking Generator）

Set the parameters related to the tracking generator.

2.2.7.1 TG

When the TG is enabled, a signal with the same frequency of the current sweep signal will be output

from the [TG SOURCE] connector at the front panel. The power of the signal could be set through the

menu.

2.2.7.2 TG Level

Set the output power of the signal of the tracking generator.

Table 2-21 TG Level

Parameter

Explanation

Loading ...

Siglent REFL-SSA3000X Reflect Measurement Software for SSA3000X Series Spectrum Analyzers