Loading ...
Loading ...
Loading ...
143
Light status Condition/solution
The Wi-Fi Direct light is on The product is connected to a device using Wi-Fi Direct.
The power light is flashing The product is busy. Wait for the power light to stop flashing before
turning off the product.
The Wi-Fi and Wi-Fi
Direct lights are flashing
A Wi-Fi connection error has occurred. Press the Wi-Fi button to clear
the error and try again.
The ink light is on Initial ink charging or ink refilling may not be complete. See the Start
Here sheet for instructions on initial ink charging.
The ink light is flashing The product is low on ink or the maintenance box is nearing the end of
its service life. If a message to continue printing appears on your
computer, press the stop button to continue printing.
The paper light is on
No paper is loaded or the loaded paper size does not match the print
setting. Load the correct size paper in the product and press the stop
button to clear the error.
The paper light is flashing
Paper is jammed in the product or protective material remains inside.
Remove the jammed paper or any protective material and press the
stop button to clear the error.
The ink light is on
The paper light is on
The product was not turned off correctly. Press the stop button to
clear the error, then run a nozzle check and cancel any pending print
jobs. Always use the power button to turn off the product.
The ink and paper lights
are flashing simultaneously
The printer cover is open or the output selector is in the incorrect
position. Close the printer cover or change the output selector's
position.
The ink and paper lights
are flashing alternately
The maintenance box is at the end of its service life, not recognized, or
installed incorrectly. Replace the maintenance box or make sure it is
installed correctly.
All lights are flashing Paper or protective material is stuck inside the product. Open the front
cover and remove any jammed paper or protective materials. Turn the
product off and then back on again. If the error continues, contact
Epson for support.
All lights except the power
light are flashing
An error has occurred during firmware updating. Connect your product
using a USB cable and try updating the firmware again. If the error
continues, contact Epson for support.
Loading ...
Loading ...
Loading ...