Loading ...
Loading ...
Loading ...
9. EFFECTS | 49
• The Rotary speed can be continuously controlled with a Morph source, in which case the
MORPH LED will be lit. This makes it possible to set the rotary at speeds other than just fast,
slow and stopped.
The DRIVE knob controls the amount of overdrive. This simulates the pre-amplifier overdrive of the
original rotary speakers.
A sustain pedal or a foot switch that is connected to the Rotor pedal input can control the rotor
speed. On the Nord Stage 3 Compact model, the optional Nord Half Moon Switch can be used
for switching Rotary speed in an even more traditional fashion. Read more about rotor control on
page 54.
M The Rotary Drive parameter is dependent on the processed instrument’s Level setting. If the
instrument being processed by the Rotary is set to a very low level, the amount of available
drive will be significantly reduced. Again, this is very much like how it works with the “real
articles” - when you increase the organ level, e.g. by using a swell pedal, the amount of
distortion from the Rotary effect increases.
ROTARY SPEAKER AND REVERB
If Reverb is active on a panel where the Rotary Speaker effect is turned on, a “copy” of that Re-
verb will be applied to the audio going into the Rotary. In other words, Reverb is applied before
the Rotary Speaker, for any sound engine assigned to it.
E If the Rotary Speaker is active on both panels, its Reverb is controlled from Panel A.
ROTARY MENU SETTINGS
There are several parameters in the Sound Menu that allow for detailed adjustments of the be-
haviour and sound of the Rotary Speaker. Read more about on this on page 55.
Loading ...
Loading ...
Loading ...