Loading ...
Loading ...
Loading ...
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specications without prior notice
20
PERLICK NITRO BEVERAGE DISPENSING KIT
Operation/Installation Manual
1. Ensure there is a nitrogen line connected to the input of
the nitrogen infuser and the air distributor.
2. Make sure the beverage tubing is connected to the input
of the nitrogen infuser and attached to a BLACK quick
disconnect.
3. Check that there is a gray quick disconnect attached to a
air distributor line.
4. See if quick disconnects are properly placed on the tank
according to Operation 7.
5. Conrm the connection is made from the regulator to the
air distributor.
a) If two air distributors are used, check the
connections to the barbed tee tting, air distributors,
and regulator.
6. Ensure the regulator is tightly axed to the tank.
7. Tug each line installed to ensure a secure connection is
made between the hose barb and the line.
a) If the line makes any indication that its slipping out
of the worm drive clamp, uninstall the clamp and redo
this connection.
8. Before opening regulator and setting pressure, ll kegs
with desired beverage.
9. Set the regulator to 28 PSI.
10. Wait 1-2 minutes for the system to pressurize.
11. The system is ready dispense!
LINE SETUP CHECK SINGLE INFUSER
(
FOR POST
-
INSTALLATION & CLEANING
)
All Components shown are reference only
Fig. 20
(Line Setup Check for Single Infuser)
Loading ...
Loading ...
Loading ...