Loading ...
Loading ...
Loading ...
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specications without prior notice
11
Form No. Z2751
Rev. 05.26.21
PERLICK NITRO BEVERAGE DISPENSING KIT
Operation/Installation Manual
1. Mark holes according to the drill sites below with a
hammer and center punch. Place the mounting template
in the corner of the refrigeration unit according to the
direction below. The mounting template (1031023) can be
found in the kit and on perlick.com.
2. Drill the six mounting holes shown on this page with a
5/32” drill bit.
NOTICE
Any deviation from this pattern more than
a 1/2” from it’s original location can result
in electrical or refrigerant damage.
OPERATION #1
–
MOUNTING LOCATIONS FOR DUAL INFUSER
Side Condensing
Back or Remote Condensing
Side Condensing
Back or Remote Condensing
For units without side
condensing (HC, HP, and
Remote Refrigeration Units),
measure from the reference
point in the upper-left corner
of the right wall.
For side condensing units, the upper
corner, opposite of the condensing
unit that is also a part of the back wall,
should be used.
Indicates reference point in the
corner where measurements must
be taken from
Border represents an internal
refrigerator side wall
(Always drill on right wall unless
there is a condensing unit next to
it, then drill on the left/opposite
wall).
Optional
Mounting hole for
P-Style mounting clamp
2 required mounting
holes for bracket and
air distributor
Required for safety chain
if using a nitrogen tank
inside unit
4 mounting holes
for nitro infuser
DRILL SITES
Loading ...
Loading ...
Loading ...