Loading ...
Loading ...
Loading ...
English 59
Maintenance
02
4. Remove the second sheet from the door
in the arrow direction.
03
5. Remove the third sheet from the door
in the arrow direction.
6. Clean the glass with soapy water and a
clean cloth.
CAUTION
To identify the correct side of the sheet,
locate the “PYRO” mark on the corner of
every sheet.
Correct direction: PYRO-**-**
Wrong direction:
02
03
01
01 Support clip 1
02 Support clip 2
03 Support clip 3
7. When done, reinsert the sheets as
follows:
• See the picture and locate the
hinges. Insert sheet 3 below
support clip 1, sheet 2 between
support clip 1 and 2, and sheet
1 into support clip 3 in this order.
Make sure the printed side of
sheets is inserted inward.
8. After insert the sheet 2, press down the
glass clips and check if they secure the
glass sheet properly.
9. Follow steps 1-2 above in the reverse
order to reinstall the coverings.
WARNING
To prevent heat leaks, make sure you
properly reinsert the glass sheets.
Dual door glass (applicable models only)
1. Tie the wet tissue to stick.
2. Put on the towel below door.
3. Clean the door.
4. Apply detergent to tissue and clean
again.
5. Wipe the dry tissue to the moisture and
bubble.
CAUTION
Do not detach the door for cleaning.
DG68-01471G-00_IBIM(FULL)_NV7000B_SA_EN_230427.indd 59DG68-01471G-00_IBIM(FULL)_NV7000B_SA_EN_230427.indd 59 2023-04-27 오후 4:16:112023-04-27 오후 4:16:11
Loading ...
Loading ...
Loading ...