Loading ...
Loading ...
Loading ...
32
75D2525
DVM Series Direct Vent Gas Fireplace
This appliance is equipped with a pilot which must be lit with built-in ignitor while following
these instructions exactly.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next
to the oor because some gas is heavier than air and will settle on the oor.
• Turn off all gas to the appliance.
• Open windows.
• Do not attempt to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the re department.
Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair it. Call a qualied service technician. Force
or attempted repair may result in a re or explosion.
Do not use this appliance if any part of it has been under water. Immediately call a qualied
service technician to inspect the appliance and to replace any part of the control system
and any gas control that has been under water.
Purge air from the supply line as follows:
• Open main shutoff valve.
• Unscrew main pressure test point.
• Leave inlet test screw open until gas comes in.
• When gas is owing, tighten inlet screw immediately.
1. Follow the pipe from the gas supply line connection to the gas valve. Check connection for
leaks with soap and water mixture.
2. Next check for gas leaks at the burner with soap and water mixture.
3. Check the pilot for gas leaks with soap and water mixture.
Loading ...
Loading ...
Loading ...