Loading ...
Loading ...
Loading ...
20
www.KALORIK.com
EPCK 45028 - 200528
• Make sure to empty, clean and replace the dew collector before
each use.
Note: If the gasket is not positioned properly, the unit will not build
pressure. The silicon gasket must always be properly positioned. Check
periodically to make sure that it is clean, flexible, and not cracked or
torn.
• If the silicon gasket is damaged, do not use the appliance and
contact our Customer Service department (see the ‘WARRANTY’
section).
• Never use abrasive cleaners or scouring pads to clean any of the
parts.
• Make sure that the parts are clean and dry before storing
DO NOT IMMERSE THE HOUSING IN WATER OR ANY OTHER LIQUIDS!
To clean the valves
• Check that the steam release knob and the pressure safety valves
are in good working order before each use.
• After the unit has cooled, remove the lid.
• Turn the lid upside down and remove the anti-block shield. Simply
pull firmly on the anti-block shield to remove. Check the exhaust
valve (also referred to as pressure regulator valve) and clean if
necessary.
• Using a brush, check for and remove any food or foreign particles
that may be lodged in the exhaust valve or floating valve.
• Replace the anti-block shield on the bottom of the exhaust valve.
Firmly push the anti-block shield to secure it in position.
Any other servicing should be performed by an authorized service
representative!
TROUBLESHOOTING
If you have not added sufficient liquid and you notice that the floating
valve has not risen, but the timer is counting down, perform the
following steps:
Loading ...
Loading ...
Loading ...