Loading ...
Loading ...
Loading ...
Boiler manual: • Installation • Start-Up • Maintenance • Parts
21Part No. 550-110-275/1018
Complete block assembly & install jacket
(continued)
Figure 25 Model 94 boiler jacket cartons and contents
Carton # Description Contents
94-EP End panel
(1) RF front panel | (1) BA back panel | (8) brackets | (47) #10 x ½" type A sheet metal screws
(8) #C-8616-5618 Tinnerman speed nuts | (8) 7/16" I.D. x 1 3/8" O.D. x .038" washers
(8) 5/16-18 N.C. x 1½" round head screws
94A
*
Side panel
(2) side panels
Panel width sux: A or AK = 30" | B or BK = 36" | C, CK or CKK = 42" | D, DK or DKK = 48" | E, EK or EKK = 54"
[Note: sux "K" means one (1) of the side panels has two (2) tankless heater openings; "CKK or DKK" indicates three (3)
tankless openings and "EKK" indicates four (4) tankless openings]
94A Top panel
(2) top panels [Sux "0" indicates top panels have top out cutouts.]
94-SC Splice channel
carton
(2) side splice channels | (1) top splice channel | (8) brackets | (42) #10 x ½" type A sheet metal screws
(8) 5/8"-11 N.C. hex nuts
Carton quantities
Boiler
model
End panel
cartons
Splice channel
cartons
Side panel cartons Top panel cartons
94-EP94-SC A BCDEABCDECOEO
8
1- - --1----1---
9
1- - ---1----1--
10
11 2 ----2------
11
11 1 1---11-----
12
11 1 -1--1-1----
13
11 - 11---11----
14
11 - -2----2----
15
11 - -11---11---
16
11 - -1-1--1-1--
17
11 - --11---11--
18
11 - ---2----2--
19
12 1 -2--1-2----
20
12 - 12---12----
21 Steam
12 - -3----1--2-
21 Water
12 - -3----2--1-
22 Steam
12 - -21----1-2-
22 Water
12 - -21 - - - 11 - 1 -
23 Steam
12 - -2-1----12-
23 Water
12 - -2-1--1-11-
24 Steam
12 - -111 - - - 1 - 11
24 Water
12 - -111 - - - 111 -
25 Steam
12 - -1-2----111
25 Water
12 - -1-2----21-
* If the boiler was ordered with tankless coil(s), jacket side panel(s) with tankless coil knockout openings will be furnished. It is important that
the TI section(s) (where used) be positioned in the exact location(s) in the section assembly as shown in the boiler erecting instructions (see
Figure9,page10) so the tankless coil knockout openings in the jacket side panel(s) will accommodate the tankless coil(s). If the TI section(s)
and tankless coil(s) are not positioned in the boiler section assembly as directed, the installer must cut opening(s) in the jacket side panel(s) to
accommodate the coil(s).
Loading ...
Loading ...
Loading ...