Loading ...
Loading ...
Loading ...
Blade Guard, Anti-kickback
Pawls and Spreader
The blade guard, anti-kickback pawls and
workpiece spreader are designed to reduce or
eliminate the risk of injury, from blade con-
tact, workpiece kickback and wrong way feed.
The Blade Guard:
• serves as a partial barrier to help
keep hands from contacting the blade
at the infeed end of the saw blade.
• helps keep the workpiece from lifting
or fluttering during ripping.
• helps catch or deflect workpiece chips
or pieces of the blade.
The Anti-Kickback Pawls :
• help reduce kickback by grabbing into
and holding the workpiece.
The
act as a barrier to provide some
protection from blade contact.
Spreader:
helps keep the kerf of the workpiece
open, which helps prevent the blade
from being pinched and causing
workpiece kickback.
when correctly set, helps reduce or
eliminate the chance of wrong way
feed because it blocks the workpiece
from contacting the saw blade.
'_ WARNING: The anti-kickback pawls
and spreader adjustments must be made
each time a different thickness workpiece
is cut to reduce or eliminate kickback.
Rip Cutting Checklist
Use the following rip cutting checklist at the
beginning of each new cutting period to
reduce the risk of an accident.
to side,
Arbor nut snug.
for cut.
Swivel, bevel, rip, miter and table =
locks locked:
Blade guard, anti-kickback pawls and
spreader adjusted.
Use push block if cutting between: 1'127
and 2 inches off workpiece. !:,
Use featherboard if making a non-thrc
cut and when needed on through cuts.
Read and follow instructions for the type
of rip cut you want to make.
46
Loading ...
Loading ...
Loading ...