Loading ...
Loading ...
Loading ...
6. Attach the four (4) lower stiffeners to the
legs'. Two (2) truss head bolts, washers, and
nuts are required to hold each end of a lower
stiffener in place. Hand tighten hex nuts.
Leg
7. Go back with a 7/16 wrench or socket and
tighten all hex nuts.
8. Carefully lift the saw into its normal posi-
tion. It will be necessary to have someone help
you in order to avoid damaging the saw.
Adjusting Leveling Feet
[L
dl& WARNING: Saw blade can roll for-
ward toward you if the leveling feet are not
correctly adjusted. Workpiece or saw can
move unexpectedly if cabinet rocks. Fin-
gers, hand, or arm can be cut off from
blade contact. Adjust leveling feet before
using your saw.
1. If the leveling feet raise the front of the saw
slightly higher than the rear, and if the leg set
does not rock, go to step 7, or
If the leveling feet do not raise the front of the
saw slightly higher than the rear, go to step 2, or
If the leg set rocks, go to step 2.
2. Loosen the bottom hex nut on the desired
leveling foot using a 9/16 inch wrench.
3. Loosen the top nut by hand.
4. Adust the lower nut with the 9/16 inch
wrench until the leveling foot is at the desired
height.
5. Tighten the top nut by hand.
6. Repeat steps2-5 for the other three leveling
feet if necessary.
7. Tighten all four bottom nuts using a 9/16
inch wrench.
Attaching Trim Caps
1. Find the left and right trim caps.
2. There are two plastic stubs on the back of
each trim cap.
3. These stubs will snap into matching holes at
the front corners of the saw.
4. Snap the left and right trim caps into place.
Trim Cap
12
Loading ...
Loading ...
Loading ...