Loading ...
Loading ...
Loading ...
Mounting the Front Table
1. Make sure that the front table is upside
down.
2. Place a tee nut over the leveling hole and
hammer it into place. (Figure 42)
Tee NL,t ---.-._,_ //_7_...
Leveling Hole ___i -_" _j_- "_o
Fig. 42
Bolt
Head Screw
Loc
Hex Nut Mounting Holes
;rew
Leveling Hole
Fig. 46
Fig. 43 - Nut Tee
5. Start the cup point set screw through the lev-
eling hole. Do not tighten. (Figures 46 & 47)
3. Slide a U-ctip onto the center channel of the
saw as shown. (Figure 44)
U Clip
\
Fig. 47 - Cup Point Set Screw
6. Put a washer in each of the mounting holes.
(Figures 46 & 47)
Fig. 48 - Washer for Mounting Holes
Fig. 44
Fig. 45- U Clip
4. Place the front table on the saw so that the
mounting holes in the table line up with holes
in the table supports and center channel of
saw. (Figure 46)
7. Start a pan head machine screw through the
center mounting hole. Do not tighten. (Figures
46 & 49)
Fig. 49- Pan Head Machine Screw
2O
Loading ...
Loading ...
Loading ...