Loading ...
Loading ...
Loading ...
Installation Instructions
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
8
65
ROUTE AND ATTACH THE PLASTIC
WATER LINE
• Fasten the plastic water line to the back of the
cabinet with adhesive-backed fastener (5).
7
Adhesive-backed fastener
for plastic water line
CONNECT THE WATER LINE
• Remove the small plastic cap (B) from the bottom of
the water tube inlet located behind the tube cover.
• Squeeze the ends of the hose clamp (6) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1″ [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
6
6
Water tube
inlet
B
REMOVE THE TUBE COVER
• At the bottom right rear of the refrigerator, remove the
screws holding the tube cover (A) to the case back.
• Remove the cover to gain access to the water tube
inlet.
• Be sure to save the screws, as the tube cover must
be reinstalled after the water line has been
connected to the water tube inlet.
5
A
Loading ...
Loading ...
Loading ...