Loading ...
Loading ...
Loading ...
INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the template
on page 66) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Cut the fill tube extension (10) to the length
(refer to the template on page 67) with a sharp
knife or a single-edge razor blade.
• Slide the fill tube extension (10) completely over
the fill tube on the water tube inlet (15).
• On the tube side of the water
tube inlet (15) there is an
adhesive backing. Remove the
backing and slide the tube into
the hole on the back of the
refrigerator as shown. Firmly
press on the inlet to secure it.
J
J
J
J
3
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS J
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator— or
TSRQPNMLKJHGFC
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
26
REMOVE ICE CUBE TRAY SHELF
If your refrigerator has an installed ice cube tray
shelf, use a Phillips screwdriver to remove the two
screws. Remove the ice tray shelf. Install the screws
in the back two holes until the screw heads are
about 1/2″ (13 mm) from the side wall of the freezer.
If your refrigerator was not originally equipped with
an installed ice cube tray shelf, use the screws (14)
that are supplied in the kit.
Place the shelf, flat side up, in the lower basket with
the sloped end at the back.
1
PREPARE THE REFRIGERATOR
Find the sticker located
on the back of the
refrigerator about
midway up on the right
hand side. Remove the
sticker and clear away
any foil tape from the
opening. Also remove
the sticker from the top
left corner of the freezer
compartment.
Remove the gray insulation plug that fills the hole
through the cabinet.
2
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
4
Partially reinstall two
screws in rear two holes
Remove sticker
Remove
sticker
Remove
insulation plug
1/4″and 5/16″ Nutdriver or adjustable wrench
15
16
L
o
r
e
m
i
p
s
u
m
d
o
l
o
r
s
i
t
a
m
e
t
L
o
r
e
m
i
p
s
u
m
d
o
l
o
r
s
i
t
a
m
e
t
Power
Switch
Hole for
wire tie
(Appearance may vary)
Loading ...
Loading ...
Loading ...