Loading ...
Loading ...
Loading ...
INSTALL FILL TUBE
• Slide the insulated fill tube (21)
onto the water tube inlet (15),
making sure that the open side
of the fill tube faces up.
• Go to the back of the
refrigerator. On the tube side
of the water tube inlet (15) there is an adhesive
backing. Remove the adhesive backing and slide the
tube into the hole near the top at the back of the
refrigerator. Firmly press on the inlet to secure it to
the refrigerator.
1
3
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS K
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator— or
TSRQPNMLKJHGFC
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
5
INSTALL MOUNTING BRACKET
• Remove the three small plug buttons on the rear
wall of the freezer and replace them with three
screws (27) supplied with the icemaker kit. Do
not screw them all the way in. The screws should
extend approximately 1/4″ (6 mm) out from
the freezer wall.
• Install the icemaker
bracket (26) by hanging
it from the three screws
that were just installed.
Tighten the three screws
securely.
4
Remove
plug
15
21
PREPARE FOR INSTALLATION
• Remove the
upper
outlet cover with a flat-blade
screwdriver.
• If there is already an icemaker bracket (26) installed in
the freezer, remove the two screws holding on the cover.
Remove and discard the cover. Go to Step 5.
2
REMOVE FILL HOLE PLUG
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
Cover
30
Power
Switch
Hole for
wire tie
(Appearance may vary)
Loading ...
Loading ...
Loading ...