Loading ...
Loading ...
Loading ...
• Fasten the water valve to the
cabinet edge hole
using the hex-head screw
that you removed
at
the beginning of Step 2.
DO NOT DRILL ANY ADDITIONAL HOLES.
• Check the plastic water line nut on the bottom
of the water valve to be sure it is hand tight.
DO NOT USE TOOLS.
16
Installation Instructions
REMOVE THE COVER
At the bottom rear of the refrigerator, remove the
screw(s) holding the compressor compartment cover
(if covered) and save for reinstallation later. Bend the
cover back for access to the compartment.
1
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS F
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator— or
TSRQPNMLKJHGFC
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4″ Nutdriver
ATTACH THE WATER VALVE
• Locate the female connector plug (C) which is
attached to the cabinet by a metal or plastic clip.
Remove the clip by removing the screw. Save the
screw for mounting the water valve later. Discard
the clip.
2
• Plug the female connector (C) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
Metal or
plastic clip
C
C
4
Loading ...
Loading ...
Loading ...