Loading ...
Loading ...
Loading ...
Installation Instructions
REMOVE THE COVER
Use a nutdriver or an adjustable wrench to remove
the compressor compartment access cover. This
requires removing six screws which attach the cover
to the back of the refrigerator case.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
1
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS K
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator— or
TSRQPNMLKJHGFC
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4″ and 5/16″ Nutdrivers, or adjustable wrench
ATTACH THE WATER VALVE
• Visually inspect your
model. It may be a 3-pin
or a 2-pin model.
• Locate the 3-pin male
connector plug (C). Plug
the water valve wire
adapter (25) onto the
male connector plug, then plug it onto the male
terminals on the water valve (4). Either wire can
go on either water valve terminal.
• Locate the red 2-pin
female connector plug
(A). Plug the red female
connector (A) onto the
red male terminal.
Locate the white female
connector (B). Plug the
white female connector (B) onto the blue male
water valve terminal.
2
• Fasten the water valve to the cabinet using the
hex-head screw (13) from the kit.
13
C
4
INSTALL WATER LINE CLAMP
• Attach the water line clamp (strain relief) (8) to the
refrigerator. Drive the screw (7) from the kit through
the clamp (8) and into the small hole at the back of
the cabinet.
• The water line clamp is for the house water line (see
the Water Line Installation Instructions). It is not to
be used for the tubing from the water valve up to
the icemaker.
3
8
25
A
B
8
7
32
3-pin models
2-pin models
Loading ...
Loading ...
Loading ...