Loading ...
Loading ...
Loading ...
EN
61
Description Message SolutionMessage
This message is displayed when the CPU does not
understand an instruction.
This message is displayed when the CPU does not
detect a full signal from the steam boiler within a
set time interval.
This message is displayed when the CPU does not
receive any signal from the Safety Probe in the
steam boiler.
This message is displayed when the CPU does not
receive the appropriate signal from the owmeter.
This message is not active in MP machines.
Most likely the machine power was disconnected without rst turning off the machine through the
keypad and display. Turn off machine using main switch. This should clear the error.
When this message is displayed the CPU also shuts down and turns the machine off. Water is not
entering the boiler. Call an authorized service technician to repair this fault.
When this message is displayed the CPU turns off power to the steam boiler heating element. The
only way to reset this error is to repair the Safety Probe to restore the signal to the CPU.
When owmeter alarm is displayed, the light on the button that initiated the brew cycle will begin
to ash. This problem is a result of water not owing through the ow meter. This can be caused
by coffee ground too ne or packed too tightly (try a coarser grind or lighter tamping) or a blockage
in the tubes, a malfunctioning water pump, a faulty valve, or a damaged owmeter. Call a service
technician to x this problem.
Troubleshooting
• This espresso machine is equipped with several feedback mechanisms that alert the operator when an unusual condition occurs.
Additionally the espresso machine will warn the operator when certain parameters fall below or above the programmed point. These
errors and warnings will appear as a message in the display.
• The following section will describe errors and warnings that may appear in the display.
Corrupted
Data
Filling-up T-out
Alarm
T.Probe Unconnect
Boiler temp.
Flowmeter
Alarm
Loading ...