Loading ...
Loading ...
Loading ...
EN
28
1. Please follow this procedure to connect the GS/3 to
the mains water supply and the waste water drain
system:
2. Turn off the machine and remove the plug from the
socket.
3. Remove the drain box, slide out the water reservoir
from the machine base.
4. Remove the left side panel assembly. Disconnect the
hose from the top of the reservoir and remove the
water reservoir.
5. Remove the drain box cap.
6. Remove the drain box cap and insert the drain box
hose barb tting (F.8.002) Do not over-tighten this
part. Over-tightening will damage the drain box.
7. Connect the clear armoured drain hose to the hose
barb tting and to the waste drain using the supplied
hose clamp.
8. Tighten the supplied hose clamp.
9. Connect the stainless steel braided hose (L325
or L326) to the water pump and pass through the
access hole on the base under the pump. This hose
will connect the pump to the mains water supply.
10. Replace the drain box on the machine base.
11. Reconnect the power plug to the power outlet.
Turn on the water supply and the main power
switch, check for leaks.
12. Congure the “Water Tank” parameter in the software
to “not present” (see the Software Programming
Guide for directions).
13. Turn on the machine.
(These instructions are also available on the website.
http://techcenter.lamarzocco.com.)
Left side panel
assembly
Access Hole
Pump Inlet Tube
Water Pump
L325 (CE)
L326 (ETL/USA)
F.8.002
H.1.010.01
F.8.003
L312
L308
913 (CE) / 914 (ETL-USA)
WARNING
WHEN THE MACHINE IS PLUMBED-IN
TO WATER MAINS, ENSURE AT EACH
INSTALLATION A NEW SET OF TUBES FOR
PLUMBING AND RELATED GASKETS IS
USED.
Loading ...
Loading ...
Loading ...