Loading ...
Loading ...
Loading ...
EN - 14
The chainsaw must be used
•
position that allows him to use both hands;
• the operator needs to use one hand to
• the cutting involves extension of the operator's
The operator must never:
• perform cutting operations with the
the point of the chainsaw bar;
• “hold and cut” sections;
• attempt to catch falling sections.
6.8 ADVICE FOR OPERATION
IMPORTANT Stop the machine (par.
6.9) when moving between work areas.
Stop the machine immediately
if the chain stops during sawing.
pruning high up (using a rope and a
belt harness), the operator must:
1.
2.
or to a rope not attached to the tool;
3. pull the chainsaw out from the cut,
4.
chainsaw to free the trapped chainsaw,
cutting at a minimum distance of 30 cm from
the trapped chainsaw. Cutting operations to
towards the end of the branch, (i.e. between
the trapped chainsaw and the end of the
trapped chainsaw). This will prevent the
complicate the situation even further.
6.9 STOP
To stop the machine:
1. Release the throttle trigger lever (Fig. 16.A).
2.
After releasing the throttle
control it takes a few seconds for
the toothed chain to stop.
–
Do not keep your nger on the safety
button when moving the machine to avoid
accidentally enabling the machine.
6.10 AFTER USE
6.10.1
1.
(Fig. 37.B) and recharge it (par. 7.2.2);
2. Mount the protection bar cover (Fig. 1.K);
3. allow the motor to cool before
storing in an enclosed space;
4. loosen the bar fastening nut to
reduce chain tension (par. 6.1.3);
5.
and remove all traces of sawdust or oil
deposits from the chain (par. 7.4);
6.
damaged components and tighten
6.10.2
1.
switch to "OFF" (Fig. 14.B);
2.
from the machine (Fig. 37.P);
3.
4. disconnect the connection cable
5.
(Fig. 38.B) and recharge it (par. 7.2.2);
6. Mount the protection bar cover (Fig. 1.K);
7. allow the motor to cool down
before placing the machine
8. loosen the bar fastening nut to
reduce chain tension (par. 6.1.3);
9.
and remove all traces of sawdust or oil
deposits from the chain (par. 7.4);
10.
damaged components and tighten
IMPORTANT Always remove the battery
(par. 7.2.2) and fit the blade guard whenever
the machine is unused or left unattended.
Loading ...
Loading ...
Loading ...