Loading ...
Loading ...
Loading ...
EN - 11
6.3 PREPARING TO USE THE
CHAINSAW ON THE TREE
strap with end slots suitable for attaching
it to the operator’s belt harness.
1.
to the fastening point (Fig. 18.A)
on the rear of the chainsaw.
2. Provide suitable clasp clips to allow
end slots) and direct (on the chainsaw
fastening point) fastening of the chainsaw
to the operator's belt harness.
3.
4.
is engaged (par. 5.4).
5. Pass the machine to the operator
situated on the tree.
Check that the chainsaw is connected
securely when passed to the operator
in the tree and check that it is fastened
to the belt harness before releasing it
from the equipment used to lift it.
6. Fasten the chainsaw to the fastening
point on the operator’s harness (Fig. 19).
The fastening points can be central
points (front or rear) or side points:
– where possible, connect the saw to the
rear centre point (Fig. 18 A) to prevent it
from interfering with the climbing ropes
and ensure that the weight is supported
NOTE The possibility of fastening the
chainsaw directly to the belt harness
reduces the risk of damaging the equipment
whilst moving around the tree.
The chainsaw must always
be switched o when it is directly
fastened to the belt harness.
IMPORTANT When moving the chainsaw
from one fastening point to another, make sure
the machine is fastened to a new position before
unfastening from the previous fastening point.
6.4
6.4.1
1. Remove the bar cover guard (Fig. 1.K) and
2.
3.
housing (par. 21 B) (par. 7.2.3).
4.
5.
and throttle trigger lever. (Fig. 16.A).
6.4.2
1. Remove the bar cover guard (Fig. 1.K) and
2. lthe bar and the chain are not
touching
3.
its housing on the machine (Fig.21.P).
4. Connect the connection cable to
5.
the selector switch (Fig. 14.B).
6.
(blue light) (Fig. 15.A).
7.
and throttle trigger lever. (Fig. 16.A).
6.5 WORKING
Before felling or delimbing for
–
–
regulations and user instructions
contained in this manual;
–
or attached to trestles, in order to
get familiar with the machine and the
most suitable cutting techniques.
To use the machine proceed as follows:
•
•
both hands, with the left hand on the front
hand grip and the right hand on the rear hand
grip, even if the operator is left-handed.
Stop the machine immediately
if the chain stops during sawing.
Loading ...
Loading ...
Loading ...