Loading ...
Loading ...
Loading ...
Programmingthe commands of remote controllers
for other devices intothe remote controller
2 to 6 inches
(5 to 15cm)
SEND/LEARN
ENTER
Programming procedure
When programming the commands of anolher remole controller 1o
the RC-460M remote conlroller, you must first decide under which
MODE button you want the commands to be linked. In general, you
will select the MODE button 1halcorresponds 1othe component you
are programming. For example, if you are programming the
functions from a remota controller for a compact disc player, you
would choose the CD MODE butlon. Then, by pressing the CD
MODE button, the buttons on the RC-460M remote controller will
change Io the commands you program here Io operate the compact
disc player.
After programming which MODE button to use, you will then
transfer the separate commands from the o_her remole controller
over to the RC=460M remote controller one at a time. Each
command is then programmed 1oa different button on the RC=460M
remote controller. Any button is programmable for this step except
for the eight MODE buttons (RCVR, CD, DVD, MD, SAT, CABLE,
VCR, and TV), the two MACRO butlons (DIRECT and MODE),
and the LIGHT button.
Even aBer the commands have been memorized, keep your old
remote controller in a safe place. If for some reason the commands
are lost (e.g., when the batteries run down), it will be necessary Io
memorize them once again.
1. Place the remote controller and the remote controller
for the other device facing each other at a distance of
2 to 6 inches (5 to 15 cm) apart.
2.
3.
While pressing and holding down the desired MODE
button on the remote controller, press the ENTER
button and then release both buttons.
When you press and hold down the MODE btalota the SEND/
LEARN indicator lighls. When you press the ENTER button, the
lamp turns oft'. When you release the buttons, the lamp lights
again.
Press and release the button on the remote controller
to which you want to transfer the next command.
You may select any button but the eleven ones indicaled in the
figure below. When you press the button, the SEND/LEARN
indicalor turns off. When you release the button, the indicator
lighls again.
If you press the wrong button by mistake, press that same button
again. The SEND!LEARN indicator flashes twice, and the
remole controller exits the programming mode.
DIRECT
MACRO
m
LIGHT
MODE
MACRO
MODEbu_ons
: Buttons that cannot be programmed.
64
Loading ...
Loading ...
Loading ...