Loading ...
Loading ...
Loading ...
Enjoying music or videos with the TX-DS797
DISPLAY DIMMER
sl s@@ss; 6ssss'@Q:@
Inputsource buttons
I Switching the display
SLEEP
RCVR
CH SEL
DISPLAV
TEST
_ LEVEL•/A
_DIMMER
While listening Io or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the DISPLAY butlon on the TX-DS797 or the remote
controller.
TX-DS797 Remote controller
+10
_rSPLAY
When an input source other than FM or AM is selected:
Input + volume
Program format*
Input +
Listening mode
or Multi Ch
L.''-..'L.' i i_i
,L
* If the input signal does not have a program format, then this will
be skipped.
When FM or AM is selected as the input source:
FM/AM frequency + L_;:h'_ ,-t_.-, _ ,-,P_L_-_ f
Preset no. ! _ _,:3. _, !.J,','_x.
$
FM/AM + I F-" '---"-......
Listening mode
Using the sleep time (remote controller only)
The SLEEP betlon enables you to set the TX-DS797 to turn off
aulomatically after a specified time period. If you press it once, the
TX-DS797 will turn off after 90 minutes. Each time it is pressed
thereafler, the remaining time until the TX-DS797 turns off
decreases by 10 minutes. While, the sleep function is enabled, you
can press the SLEEP button to see how much time is left. To cancel
the sleep function, press the SLEEP button when the time displayed
is less than 10 minutes.
If you are using the remote zone (Zone 2), it will turn off at the same
time as the main zone. If you want to set the sleep function for Zone
2 only, set the sleep function with main zone turned on and then put
the main zone into the standby state. Remote controller
_. ee r 9 °.;. i '-
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between -12 to +12
decibels. Note that the calibration settings will return to the original
settings when the TX-DS797 is put in standby.
1. Press the RCVR MODE button.
2. Press the CH SEL button and select
the desired speaker.
3. Press the LEVEL • or • button to
adjust the volume level.
I Adjusting the of the front
brightness display
You can adjust the brightness of the front display of the TX-DS797
with DIMMER button on the remote controller or on the TX-DS797
front panel wilh other than European models.
TX-DS797 Remote controller
_M_E_ 0
52
Notes:
• You cannot select a speaker if the Speaker Config sub-menu of
the Speaker Setup is set to No or None.
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
• When you press the TEST button after you set the level, the
current level will be used as the value set via the test tone.
Loading ...
Loading ...
Loading ...