Loading ...
Loading ...
Loading ...
12
XBR 95 STEP FOUR
HARDWARE FOR STEP 4
PART TYPE DESCRIPTION QTY
70 BOLT
5/16”XUNC18X1-1/4”
1
76 FLAT WASHER
Ø5/16” × Ø18 × 1.5T
1
91 NYLOC NUT
5/16”X6T
1
105 SHEET METAL SCREW
4X16MM
4
1. Gather HARDWARE FOR STEP 4.
2. Install the GAS CYLINDER (57) on the SEAT
BACK FRAME (5) with 1 BOLT (70), 1 FLAT
WASHER (76) and 1 NYLOC NUT (91) by
using the WRENCHES provided (112 & 113).
3. Attach the PEDALS (116L, 117R) to the
CRANK ARMS (51L, 51R). Tighten with
the WRENCH (113). Remember that the
LEFT PEDAL has a reverse thread and
will be threaded onto the Crank arm in a
COUNTERCLOCKWISE motion. There is an
“L” stamped in the end of the threaded post of
the left pedal and an “R” in the right. Make sure
to tighten the pedals as rmly as you can. It may
be necessary to re-tighten the pedals if you feel a
thumping while pedaling the bike. A thumping or
clicking noise is usually caused by loose pedals.
4. Attach the DRINK BOTTLE HOLDERS (39L
& 38R) to the sides of the SEAT HANDLE
BAR (6) with 4 SHEET METAL SCREWS
(105). Tighten with the PHILLIPS HEAD
SCREW DRIVER (114)
Loading ...
Loading ...
Loading ...