Loading ...
Loading ...
Loading ...
Power Failure
In the event of a power failure, only the standard STAR ®
burners can be lit manually. It is necessary to light each
standard burner individually (see also page 15).
If the range's cooktop is being used when the power failure
occurs, turn all of the burner control knobs to the OFF
position. The standard burners can be lit by holding a
match at the ports and turning the control knob to the HI
position. Wait until the flame is burning all the way around
the burner cap before adjusting the flame to the desired
height.
The two ExtraLow ® burners on the left sides cannot be
used during a power failure. Be sure to turn them OFF if a
power failure occurs because they will not turn back on u9
ntil the control knobs are turned OFF and then turned back
on again.
If you have low gas pressure, contact your gas company.
Intermittent or Constant Igniter Sparking
Intermittent or constant sparking of the sealed gas surface burners can result from a number of preventable conditions.
Eliminate these conditions as indicated in the following chart.
SYMPTOM, CAUSE' REMEDY
Intermittent sparking • Ceramic igniter is wet or dirty.
• STAR burner ports are clogged.
More than four clicks of • Improper fit of STAR burner cap
igniter before lighting onto STAR burner base.
Constant Sparking Range is not properly grounded.
Electrical power supply is incorrectly
polarized.
• Carefully dry or clean igniter.
• Clean ports on STAR burner cap with a
wire, a needle or straightened paper clip.
• Align STAR burner cap properly on
STAR burner base.
• Refer to the Installation Manual. Have a
qualified electrician ground the range
properly.
• Refer to the Installation Manual.
Have a qualified electrician ground the
range properly.
Ii
Ii
English 37
Loading ...
Loading ...
Loading ...