Loading ...
Loading ...
Loading ...
10 Philips · HDP16x0 & HDP16x0TV
3 Initial Operation
Setting up the Device
Before installing your device, make sure that the
projector is turned off and the power cord is
unplugged from the power outlet.
You can position the device so that it lies flat on a table
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com
-
pensates for the distortion from the slanted projection
(pincushion distortion).
Check that the projection surface is appropriated to the
projector. The distance between the projector and the
screen determines the actual size of the image.
To change the size of the screen, just move the projec-
tor towards or away from the wall.
The size of the screen (b) is comprised between 50 and
100 inches depending on the projection distance
(a), as
described in the following table.
Connect Power Supply
1 Connect the power cord into the socket on the rear
side of your device (1).
2 Plug the power cord to outlet on the wall (2).
Installing or Changing the
batteries of the IR Remote
Control
1 To access the battery, press to unlock the locking
mechanism (1) and slide out the battery compart
-
ment (2).
CAUTION!
Remove protection foil before operation!
Do not place any objects in front of the lens!
Diagonal size (b)
(mm)
[inch]
Projection distance
(a)
(mm)
1270
[50]
108
2540
[100]
441
a
b
CAUTION!
The power cord is used as a power unit cut
off. As a precaution, the outlet shall be located
close to the device and be of easy access in
case of danger.
DANGER!
Risk of Explosion with Incorrect Type of
Batteries
Only use the AAA type battery.
There is a risk of explosion if the incor-
rect battery type is used.
PHILIPS
VGA
1
2
S/PDIF
OPTICAL
AUDIO
OUT
TRIG
OUT
AV
IN
L
R
Screeneo_User-Manual_HDP16x0_V1-1_EN-US_253634032-A.book Page 10 Jeudi, 12. février 2015 11:31 11
Loading ...
Loading ...
Loading ...