Loading ...
Loading ...
Loading ...
▷ Have all vehicle occupants get out of the
vehicle and ensure that they remain out‐
side the immediate area in a safe place,
such as behind a guardrail.
▷ If necessary, set up a warning triangle or
portable hazard warning lamp at an appro‐
priate distance.
▷ Perform wheel change only on a flat, solid
and slip-resistant surface. On soft or slip‐
pery ground, e.g., snow, ice, tiles, etc., the
vehicle or vehicle jack can slip away to the
side.
▷ Do not place wood blocks or similar items
under the vehicle jack; otherwise, it cannot
reach its carrying capacity because of the
restricted height.
▷ If the vehicle is raised, do not lie under the
vehicle and do not start the engine; other‐
wise, a fatal hazard exists.
Information
WARNING
The vehicle jack is optimized for lifting
the vehicle and for the jacking points on the
vehicle only. There is risk of injuries. Do not lift
any other vehicle or cargo using the vehicle
jack.◀
Removing the emergency wheel
The emergency wheel and the tools are lo‐
cated in the trunk under the cargo floor panel.
1.
Remove the cargo floor panel. To do this,
pull the floor upward directly behind the
rear backrests.
2. Loosen the lashing straps.
3. Remove tool holder.
4. Remove emergency wheel.
Prepare wheel change
1.
Follow the Safety instructions, refer to
page 283.
2. With the wheel chock from the onboard ve‐
hicle tool kit, also secure the vehicle
against rolling away at the front wheel of
the opposite side. For this, place the wheel
chock behind the front wheel diagonally
across.
3. Switching off the air suspension, refer to
page 200.
4. Loosen the wheel lug bolts a half turn.
Jacking up the vehicle
1.
Place the vehicle jack at the jacking point
closest to the wheel such that the vehicle
jack foot is vertically beneath the vehicle
Seite 283
Replacing components Mobility
283
Online Edition for Part no. 0140 2 964 330 - VI/15
Loading ...
Loading ...
Loading ...