Loading ...
Loading ...
Loading ...
Servicing Your Honda
83
Drive Chain
1. Check the drive chain roller (1) for wear or
damage.
2. Measure the outer diameter of the drive chain
roller and replace it if below the service limit.
Service Limit: 0.7 in (18 mm)
Replace the roller if necessary as follows.
Remove the bolt (2), washers (3), collar (4) and
drive chain roller.
Install a new drive chain roller, collar, washers and
tighten the bolt.
1. Loosen the rear axle nut (1).
2. Loosen both chain adjuster lock nuts (2) and
turn the adjusting bolts (3) counterclockwise to
decrease slack or clockwise to increase slack.
Align the index marks (4) of the axle plates (5)
with the same reference marks (6) on both
sides of the swingarm.
3. Tighten the rear axle nut to the specified
torque:
65 lbf·ft (88 N·m, 9.0 kgf·m)
4. Recheck chain slack and adjust as necessary.
5. Turn the adjusting bolts counterclockwise until
it touches the axle plates lightly. Then tighten
the chain adjuster lock nut to the specified
torque while holding the adjusting bolt with a
wrench:
20 lbf·ft (27 N·m, 2.8 kgf·m)
Commercially prepared drive chain lubricants may
be purchased at most motorcycle shops and should
be used in preference to motor oil. Pro Honda HP
Chain Lube or an equivalent is recommended.
Saturate each chain joint so that the lubricant
penetrates the space between adjacent surfaces of
the link plates and rollers.
Drive Chain Rollers
(1) drive chain roller (3) washers
(2) bolt (4) collar
(1)
(2)
(1)
(4)
(3)
Adjustment
(1) rear axle nut (4) index mark
(2) chain adjuster lock nut (5) axle plate
(3) adjusting bolt (6) reference mark
(2)
(3)
(1)
(5)
(4)
(6)
Lubrication
31KSE7100_NA.book 83 ページ ２０１９年４月９日 火曜日 午後１時１３分
Loading ...
Loading ...
Loading ...