Loading ...
Loading ...
Loading ...
Air Cleaner
(cont’d)
Servicing Your Honda
43
Air Cleaner
Refer to Safety Precautions on page19.
The air cleaner uses polyurethane inner and outer
pieces which can’t be separated.
A dirty air cleaner will reduce engine power.
Proper air cleaner maintenance is very important
for off-road vehicles. A dirty, water-soaked,
worn-out, or defective air cleaner will allow dirt,
dust, mud, and other impurities to pass into the
engine.
Service the air cleaner more frequently if you ride
in unusually wet or dusty areas. Your dealer can
help you determine the correct service interval for
your riding conditions.
Your CRF’s air cleaner has very specific
performance requirements. Use a new Honda
Genuine air cleaner specified for your model or an
air cleaner of equal quality.
NOTICE
Using the wrong air cleaner may result in
premature engine wear.
Proper air cleaner maintenance can prevent
premature engine wear or damage, expensive
repairs, low engine power, poor gas mileage, and
spark plug fouling.
NOTICE
Improper or lack of proper air cleaner
maintenance can cause poor performance and
premature engine wear.
1. Remove the seat (page 29).
2. Remove the air cleaner retaining bolt (1) and
air cleaner assembly (2).
3. Remove the air cleaner element (3) from the air
cleaner holder (4).
4. Wash the air cleaner element in clean non-
flammable cleaning solvent. Then wash in hot,
soapy water, rinse well, and allow to dry
thoroughly.
The air cleaner element is made in two pieces:
inner and outer, which cannot be separated.
5. Clean the inside of the air cleaner housing.
6. Allow the air cleaner to dry thoroughly. After
drying, apply 1.7 US oz (50 cm
3
) of clean Pro
Honda Foam Filter Oil or an equivalent air
cleaner oil from the inside of the element.
Place the element into a plastic bag and spread
the oil evenly by hand.
7. Apply 0.09 – 0.11 oz (2.6 – 3.0 g) of Pro Honda
White Lithium Grease or an equivalent to the
air cleaner housing contact area of the air
cleaner element.
8. Assemble the air cleaner element and holder.
Install the holder tab (5) in the hole (6) of the
air cleaner tab (7).
Cleaning
(1) air cleaner retaining bolt
(2) air cleaner assembly
(3) air cleaner element (6) hole
(4) air cleaner holder (7) air cleaner tab
(5) holder tab
(1)
(2)
(7)
(5)
(3)
(4)
(6)
31KSE7100_NA.book 43 ページ ２０１９年４月９日 火曜日 午後１時１３分
Loading ...
Loading ...
Loading ...