Loading ...
Loading ...
Loading ...
98
Adjustments for Competition
Front Suspension Adjustments
17. Clean the spring and spring seat thoroughly
with a high flash point solvent to remove all
metal particles and dirt.
18. Dry the spring and spring seat with air pressure
rather than a shop towel. Using a shop towel
allows lint to stick to the springs. Lint or any
particles that stick in the damping passages can
cause inconsistent damping.
19. Turn the adjuster needle rod (14)
counterclockwise and remove it from the fork
cap (2).
Check the adjuster needle rod for bent or
damage.
Check that the O-rings (20) on the fork cap and
needle rod are in good condition. Apply the
recommended fork oil to the O-rings.
20. Loosen the lock nut (16) slightly.
21. Attach a two-foot length of mechanic’s wire
(21) to the threaded portion on the lock nut.
Wrap the wire securely around the threads.
22. Install the fork spring (17) as follows:
– With the fork spring held upright on its
marked end, feed the mechanic’s wire up
through the spring.
– Angle the fork spring and slowly slide it
down into the fork using a gentle rocking
motion.
23. Reaching through the two adjacent coils near
the oil lock valve, hold the spring guide (22)
with your finger.
Remove the mechanic’s wire and hand tighten
the lock nut (16) to the spring guide (22).
24. Set the adjuster screw (12) to 0.06 in (1.5mm)
from the fork cap (2) top, then install the fork
cap onto the piston rod.
NOTICE
When installing the fork cap, be careful not to
damage the damping force adjuster needle rod
and the needle or the rod end.
25. Hand tighten the fork cap (2) on the piston rod
(15) lightly until it stops, then tighten the lock
nut (16) to the fork cap to the specified torque:
15 lbf·ft (19.7 N·m, 2.0 kgf·m)
26. Temporarily thread the fork cap into the fork
tube.
27. Insert both fork legs into the fork clamps
(2) fork cap (20) O-rings
(14) adjuster needle rod
(16) lock nut (21) mechanic’s wire
(2)
(20)
(14)
(21)
(16)
(16) lock nut (22) spring guide
(17) fork spring
(2) fork cap (12) adjuster screw
(22)
(16)
(17)
(12)
(2)
0.06 in
(1.5 mm)
(2) fork cap (16) lock nut
(15) piston rod
(15)
(16)
(2)
(16)
(2)
31KSE7100_NA.book 98 ページ ２０１９年４月９日 火曜日 午後１時１３分
Loading ...
Loading ...
Loading ...