Loading ...
Loading ...
Loading ...
38
Servicing Your Honda
Engine Oil
6. It is recommended to replace the oil and filter
every 6 races or about every 15.0 hours.
However, if you replace only the oil before the
recommended interval, see page 21.
7. Remove the oil filter cover bolts (4) and oil
filter cover (5).
8. Remove the oil filter (6) and O-ring (7) from
the oil filter cover.
NOTICE
Using the wrong oil filter may result in leaks or
engine damage.
9. Apply grease to the filter side of the spring end,
then install the spring (8) into a new oil filter.
10. Position the spring against the engine
crankcase and install a new oil filter with the
rubber seal (9) facing out, away from the
engine. You should see the “OUT-SIDE” mark
(10) on the filter body, near the seal. Use a new
Honda Genuine oil filter or a filter of equal
quality specified for your model.
NOTICE
If the oil filter is not installed properly, it will
cause serious engine damage.
11. Apply engine oil to the new O-ring and install
it to the oil filter cover.
12. Install the oil filter cover being careful not to
damage the O-ring, then tighten the oil filter
cover bolts to the specified torque:
7 lbf·ft (10 N·m, 1.0 kgf·m)
13. Fill the crankcase with the recommended oil.
14. Install the engine oil fill cap/dipstick.
15. Check the engine oil level by following the
steps in Checking & Adding Oil (page37).
Pour the drained oil into a suitable container and
dispose of it in an approved manner (page 130).
NOTICE
Improper disposal of drained fluids is harmful to
the environment.
(4) oil filter cover bolts
(5) oil filter cover
(6) oil filter
(7) oil filter cover O-ring
(8) spring
(9) rubber seal
(10) “OUT-SIDE” mark
(8)
(10)
(7)
(6)
(9)
(5)
(4)
Capacity: 0.62 US qt (0.59 ℓ)
after draining and oil filter change
0.59 US qt (0.56 ℓ)
after draining
31KSE7100_NA.book 38 ページ ２０１９年４月９日 火曜日 午後１時１３分
Loading ...
Loading ...
Loading ...