Loading ...
Loading ...
Loading ...
Sunroof Reinitialization
The following procedure must be followed to reinitialize
the sunroof and calibrate obstacle detection:
1. Place the ignition in the RUN position.
2. Push and hold the front panel close switch until the
sunroof panel is fully closed, then release the switch.
3. Open the driver side front door.
4. Turn the ignition OFF.
5. After 10 seconds, place the ignition back in the RUN
position.
6. Push and hold the front panel close switch again. The
reinitialization process will begin within 10 seconds. Do
not release the switch.
7. The sunroof will stop and an audible “click” will be
heard.
8. Release the front panel close switch, then push and hold
it again within 5 seconds. Do not release the switch.
9. As the front panel close switch is held, the sunroof panel
will cycle to the fully open position and then back to the
fully closed position again.
10. Once all sunroof motion has stopped, release the front
panel close switch. Sunroof reinitialization and ob-
stacle calibration is now complete.
NOTE: If the switch is released prior to the sunroof
completing the above procedure, the entire process must be
repeated.
Emergency Open/Close
If the Power My Sky switch fails, the retractable roof can be
operated manually as follows:
1. Remove the protective cap located on the inner lining.
2. Remove the Allen Key or My Sky Key that is supplied in
the tool bag in the cargo area.
3. Insert the Allen Key or My Sky Key into the key hole
and turn it clockwise to open the roof or counter-
clockwise to close.
90 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...