Loading ...
Loading ...
Loading ...
NOTE:
• The Rain Sensing feature will not operate when the
wiper switch is in the low or high-speed position.
• The Rain Sensing feature may not function properly
when ice, or dried salt water is present on the wind-
shield.
• Use of Rain-X or products containing wax or silicone
may reduce Rain Sensing performance.
• The Rain Sensing feature can be turned on and off using
the Uconnect System, refer to “Uconnect Settings” in
“Multimedia” for further information.
Rear Wiper Operation
The rear wiper/washer controls are located on the lever on
the right side of the steering column. The rear wiper/
washer is operated by rotating a switch, located at the
middle of the lever.
NOTE: If the front wiper is moving and the vehicle is
shifted in REVERSE, the rear wiper will perform one round
up to clean the rear window.
Rotate the center portion of the lever upward to the
first detent for intermittent operation and to the
second detent for continuous rear wiper operation. If the
front wiper is set to Automatic Mode (on the wiper stalk as
well as “Enabled” through Uconnect settings), placing the
rear wiper in an intermittent position will cause the front
and rear wipers to sync up. Turning the front wipers off
will cause the rear wipers to also stop.
To use the washer, push the lever forward and
hold while spray is desired. If the lever is pushed
while in the intermittent setting, the wiper will
turn on and operate for several wipe cycles after
the end of the lever is released, and then resume the
intermittent interval previously selected.
If the lever is pushed while the wiper is in the off position,
the wiper will operate for several wipe cycles, then turn off.
NOTE: As a protective measure, the pump will stop if the
switch is held for more than 30 seconds. Once the lever is
released, the pump will resume normal operation.
3
GETTING TO KNOW YOUR VEHICLE 67
Loading ...
Loading ...
Loading ...