Loading ...
Loading ...
Loading ...
Enabling And Disabling Rear ParkSense
ParkSense can be enabled and disabled with the ParkSense
switch.
When the Rear ParkSense switch is pushed to
disable the system, the instrument cluster dis-
play will show a message such as “PARKSENSE
DISABLED” for approximately five seconds. Re-
fer to “Instrument Cluster Display” in “Getting To Know
Your Instrument Panel” for further information.
The Rear ParkSense switch LED turns ON when the system
is disabled by pressing the switch, as well as in case of
failure or temporary disabling conditions. The Rear
ParkSense switch LED will be off when the system is
enabled. If the Rear ParkSense switch is pushed, and
requires service, the Rear ParkSense switch LED will blink
momentarily, and then the LED will be on.
Rear ParkSense will remember the previous state when the
vehicle is switch off.
CAUTION!
After turning OFF the ignition, the Rear ParkSense
remains in this setting until the next ignition cycle,
even in the case of changing the setting of starting
RUN to OFF and then again in RUN.
Operation With A Trailer
The operation of the rear sensors is automatically deacti-
vated when the trailer’s electric plug is inserted in the
vehicle’s tow hook socket. In this situation, the ParkSense
Switch LED turns on.
The rear sensors are automatically reactivated when the
trailer’s cable plug is removed.
288 STARTING AND OPERATING
Loading ...
Loading ...
Loading ...