Loading ...
Loading ...
Loading ...
Rear bumper.
Always keep the bumper in the area of the radar
sensors clean and unobstructed.
Camera
The camera is installed near the interior mirror.
Keep the windshield in front of the interior mirror
clean and clear.
Functional requirements
▷ Speed below 130 mph/210 km/h.
▷ Sufficient lane width.
▷ Above approx. 43 mph, 70 km/h: lane mark‐
ing is detected.
▷ Below approx. 43 mph, 70 km/h: lane marking
or a vehicle driving ahead is detected.
▷ Hands on the steering wheel rim.
▷ Wide curves.
▷ Drive in the center of the lane.
▷ Turn signal switched off.
▷ The sensor system calibration process is
complete.
▷ Cruise control with distance control is active.
▷ Safety belt on the driver's side fastened.
Additionally, the following systems must be ac‐
tive:
▷ Approach control warning.
▷ Person warning.
▷ Side collision mitigation.
Switching on/off
Assisted Driving
General information
This button is used to switch the config‐
ured function on and off.
The button can be used to set the pri‐
marily used function.
Set function
1. When the system is active, press the
button repeatedly until the desired function is
selected in the function bar. The function bar
for Assisted Driving is displayed at the bot‐
tom of the instrument cluster.
▷ Cruise control with distance con‐
trol.
▷ Cruise control with distance con‐
trol and steering and traffic jam assistant.
The selected function is shown in green.
The setting is stored for the driver profile cur‐
rently used.
Switching on
1. Press the button on the steering
wheel.
2.
Adjust the steering and traffic jam
assistant if necessary.
Seite 231
Driver assistance systems
CONTROLS
231
Online Edition for Part no. 01402720932 - II/19
Loading ...
Loading ...
Loading ...