Loading ...
Loading ...
Loading ...
▷ After the drive-ready state is switched off and
selector lever position R, D or M/S is en‐
gaged.
▷ After the standby state has been switched off
when selector lever position N is engaged.
▷ If the driver's safety belt is unbuckled, the
driver's door is opened, and the brake pedal
is not pressed while the vehicle is stationary
and selector lever position D, M/S or R is en‐
gaged.
Engaging selector lever
positions
General information
To prevent the vehicle from creeping after you
select a drive mode, maintain pressure on the
brake pedal until you are ready to start.
Functional requirements
Only when the drive-ready state is switched on
and the brake pedal is depressed is it possible to
change from selector lever position P to another
selector lever position.
The selection lever position P cannot be
changed until all technical requirements are met.
Engaging selector lever position D,
N, R
A selector lever lock prevents the following faulty
operation:
▷ Unintentional shifting into selector lever posi‐
tion R.
▷ Unintentional shifting from selector lever po‐
sition P into another selector lever position.
1. Fasten driver's safety belt.
2. Press and hold the button to release the se‐
lector lever lock.
3. Push the selector lever in the desired direc‐
tion, past a resistance point, if needed. The
selector lever automatically returns to the
center position when released.
Engaging selector lever position P
Press button P.
Rolling or pushing the vehicle
General information
In some situations, the vehicle is to roll without
its own power for a short distance, for instance in
a vehicle wash, or be pushed.
Seite 145
Driving
CONTROLS
145
Online Edition for Part no. 01402720932 - II/19
Loading ...
Loading ...
Loading ...