User Manual - Page 85

For 2011 LEAF.

Loading ...
Loading ...
Loading ...
CH-32 Charging
Symptom Possible cause Possible solution
Normal charge stops in the
middle of charging.
There is no power coming from the outlet. There may have been a electrical power failure, or the breaker may have failed. Charging will
resume when the power source is reset.
The charge cable has been disconnected. Check that the charge cable has not been disconnected.
The release switch has been pressed. If the charge connector button is pressed for a long period of time, charging will be stopped.
Both the normal charge connector and the
quick charge connector were connected at
the same time.
If the normal charge connector and the quick charge connector are connected at the same
time, charging will be stopped.
Charging timer end time has been reached. When charging timer is set and the charge end time is reached, charging will be stopped,
even if the Li-ion battery is not fully charged.
The temperature of the Li-ion battery is too
hot or too cold to charge.
Confirm the Li-ion battery temperature by checking the Li-ion battery temperature gauge. If the
gauge indicates the Li-ion battery is too hot (red zone) or too cold (blue zone), charging is not
possible. Allow the Li-ion battery to cool or warm up before charging. See “Li-ion battery
temperature gauge” in the “2. Instruments and controls” section.
Quick charge cannot be
performed.
Incorrect charge connector connection, not
fully inserted or may not be locked.
Check that the charge connector is connected correctly and that it is locked.
The self-diagnostic function of the quick
charge device returns a negative result.
There is a possibility that the vehicle has a malfunction. Stop charging and contact a NISSAN
certified LEAF dealer.
The power switch of the quick charger is off. Check the power switch of the quick charger.
Quick charge stops in the
middle of charging
Charging is stopped by the quick charge
timer.
Charging will stop depending on the timer function setting of the quick charge device. If you
need to charge the Li-ion battery more, start the charging procedure again.
The maximum time for quick charge is 60 minutes. If you need to charge the Li-ion battery for
longer than this, start the charging procedure again.
Charging stops at 90% capacity.
When charging has been started when the Li-ion battery capacity is less than half, charging
will stop when the capacity reaches 90%. If you need to charge the Li-ion battery more than
90%, start the charging procedure again.
The power supply for the quick charger is off.
Check whether the power supply for the quick charger is off.
Loading ...
Loading ...
Loading ...